V6 Hose Clamps that will work in place of the factory clamps

UPDATE!

In addition to the clamps that are mentioned below, here is the name and manufacturer of the original clamps for the V6 SHO.  If you can't find what you want from this place, then try the one mentioned by Gary below.

Here is the original manufacturer of clamps for the SHO motor:

Norma Products
31132 Century Drive
Wixom, MI 48393
Phone: 248-668-9510
Fax: 248-668-9523
Website: www.norma.de


Thanks to Paul Nimz for sending me the above info.

Editors comment: Longtime SHO friend, racer, engineer and mechanic: Gary Morrell has found some clamps that will work as a replacement for the stock clamps on the SHO V6 intake manifold.  If yours are rusty and you need some new ones, check these out:

"Found a reasonable substitute for the hose clamps used on the manifold runners. They're an all stainless narrow-band unit made by Breeze, part number MAH-20. Runs from 1.18" to 1.75" diameter, about $0.90 each. They're not fully lined as the British-made OEM clamps were, but will serve the intended purpose.

Unfortunately, Breeze has nothing larger then 1.75" in a narrow band unit, so I'm still looking for clamps that will fit the connectors on the crossover tube and the splice adjacent to the throttle body. One could always splice together 2 small clamps to make a larger one."

Gary M.

mailto:comments@shoclub.com

SHOClub.com